 |
Kitchen Science ExperimentsThe Naked Scientists: Science Radio & Science Podcasts |
Superhero 3D X-ray vision
|
Next Experiment: Racing Jam Jars  If you like Kitchen Science then you'll love Crisp Packet Fireworks, our new book of home experiments, complete with illustrations and explanations. Find out more |
 Kitchen Science RSS Feed |
Water Fibre Optics
Use a bottle of water and a torch to bend light around corners, and find out what this has to do with the internet.
What you need
| A Plastic bottle |
| Something to make a hole in it with |
| A torch (flashlight if you must) |
| A Source of water |
What to Do
Make a small round (~5mm) hole in the side of the bottle near the base. It is probably best to use a drill to do this as the bottle will be very slippery.
Put your finger over the hole and fill the bottle up with water.
Shine the torch through the bottle at the back of the hole
Remove your finger from the hole and move it down the stream of water.
What may Happen
You should notice a spot of light on your hand while it is in the stream of water even though it must have gone around a corner to get there. It tends to work best when the water comes out quite slowly.
What is going on?
To understand what is going on here it helps to do another experiment. Fill a transparent bowl with water, put something in the bowl and then look upwards at the bottom of water.
|
|
If you look at the bowl from the top you can see the spoon at the bottom. | Looking upwards in the bowl of water you see a reflection of the spoon at the bottom of the bowl in the surface. The water is behaving like a mirror. |
So light will reflect really well off the inside surface of water at a relatively small angle.
This means that if you shine the light into a tube of water whenever it meets the side it is reflected so the light stays within the water until it hits your hand lighting it up. This happens even if the water goes around a corner.
What has this got to do with fibre optics?
If instead of making the tube out of water you use very very pure glass and pull it to a thin flexible fibre, when you shine light in at one end it will come out of the other. By getting the right design of fibre the light can travel through up to 50km of fibre and still be detectable. You can then send signals through the fibre by flashing the light on and off again a bit like morse code, because you can flash the light very fast you can transfer huge amounts of information. The record is now over 1000 GB per second down a single optical fibre. Because they are so good at transmitting data optic fibres move most of the data around the world (internet traffic, phone calls etc.) and you are almost certainly reading this via one.
If you make the tube out of plastic rather than glass it is more flexible and safer, and you can use it to make the artificial Christmas trees with the tiny pin pricks of light.
Why do you get such a good reflection from the surface of the water?
Light goes more slowly in water than in air and whenever light changes materials and the speed changes it will be bent (refracted). When it moves from a slow material (like water) to a faster one (like air) it is bent towards the surface.
|
|
|
If light leaves water at an angle it is refracted closer to the surface. Some light is reflected back into the water but not very much. | The smaller the angle the light meets the surface at, the bigger the change in angle. | At a certain point the refracted light should be inside the water. Light must leave the water to refract so this is impossible, so all the light is reflected. This is known as total internal reflection. |
Written by Dave Ansell
Twitter
Facebook
Del.icio.us
Slashdot
StumbleuponInformation presented on this website is the opinion of the individual contributors and does not reflect the general views of the administrators, editors, moderators, sponsors, Cambridge University or the public at large.
The contents of this site are © The Naked Scientists® 2000-2012. The Naked Scientists® and Naked Science® are registered trademarks.