The Naked Scientists

The Naked Scientists Forum

Author Topic: QotW - 15.10.06 - Why are power lines so noisy?  (Read 654 times)

Offline thedoc

  • Forum Admin
  • Administrator
  • Sr. Member
  • *****
  • Posts: 511
  • Thanked: 11 times
    • View Profile
Anders Soldal asked:

Why do power lines make so much noise?
Asked by Anders Soldal


                                        Find out more on our podcast page

 

« Last Edit: 07/10/2015 14:32:43 by _system »


 

Offline thedoc

  • Forum Admin
  • Administrator
  • Sr. Member
  • *****
  • Posts: 511
  • Thanked: 11 times
    • View Profile
QotW - 15.10.06 - Why are power lines so noisy?
« Reply #1 on: 07/10/2015 14:32:43 »
We answered this question on the show...

Charis[/i] - On Facebook, Rachel speculates that its when there's too much electricity and some tries to escape whereas Henry thinks its down to vibrations, or as Steven said, Good vibrations. Meanwhile Andrew Griffiths is a semiconductor engineer from the company IQE
Andrew - In power lines themselves, the noise is usually due to something called a corona discharge which is when the electric field is strong enough to make the surrounding air conduct. The sound you're hearing is a transfer of energy from the power line to the surrounding air. Designers of power lines want to avoid this noise as it results in a power loss. But its partially dependent on atmospheric conditions such as the air pressure and humidity. For example, if it rains, the noise can become louder due to the increased humidity, and addition of water droplets in the surface of the wires. This creates a more conductive environment. The corona discharge and therefore the noise can be reduced by making sure the power lines are thicker and the space in between the power lines is sufficient. This energy loss can also be reduced by decrease in the voltage. However, if we decrease the voltage, the current then increases. This increased current causes more power loss due to heating so you have to balance how much energy high voltage loses in noisy corona discharge and how much low voltage transmission would lose in heat.
Charis - But why does the discharge produce a steady buzzing sound?
Andrew - Electricity is distributed to homes by alternating current. Alternating current is where electric current moves backwards and forwards at 50 times a second. Any noise that you hear in power lines or transformers is associated with this frequency.
Charis - So the noise is a 50 hertz buzz produced as the voltage rises and falls in the cable, 50 times per second. But what causes the voltage in current to alternate like this in the first place?
Andrew - Domestic electricity is generated by a process called electromagnetic induction which converts movement into electricity. It does this by rotating a magnet relative to some wires. As the magnet turns, the voltage goes positive and negative because of how the wires are set up. This positive and negative changing voltage pushes and pulls the current in two directions.
Charis - Thank you to Andrew Griffiths from IQE for that answer. Next week, were hitting the road for Marco.
Marco - I was driving my truck pulling a 53-foot trailer and it blew over due to a strong wind. I was wondering if you could work out the wind speed so that I know when to stop driving.
« Last Edit: 07/10/2015 14:32:43 by _system »
 

The Naked Scientists Forum

QotW - 15.10.06 - Why are power lines so noisy?
« Reply #1 on: 07/10/2015 14:32:43 »

 

SMF 2.0.10 | SMF © 2015, Simple Machines
SMFAds for Free Forums