1
General Science / What is the strongest plastic?
« on: 30/05/2022 23:58:32 »
Hi. I want to make my own custom balloon. Which plastic film I can buy, so it will be tough enough to be used for a long time?
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
General Science / How do we make synthetic gasoline?
« on: 22/05/2022 18:17:17 »
Hi Do you know that it is possible to make substitute to gasoline from sugar, east and water. There are three alcohols that can be used in the gasoline mixture. Methanol, Ethanol and tetra something, the rest you can get from petroleum, octane booster. With this prices going up for gasoline ,it is good idea to start think about it. Not particularly can be used sugar, east and water. Can turn methane into synthesis gas and than make more stuff for synthetic gasoline mixture.
3
General Science / Is it safe to transport hydrogen gas compressed into a water tank?
« on: 15/05/2022 14:47:07 »
Hi.
Is it safe to transport hydrogen gas compressed into water tank?
Is it safe to transport hydrogen gas compressed into water tank?
4
New Theories / Can rust be removed by an electric field?
« on: 21/04/2022 12:34:55 »
Hi. I found how to remove rust using electric field. There is ultrasound rust removals, electrolysis rust removals, and now will be electric field rust removals.
Electric field rust removals are the same as electrolysis rust removals, only that electrodes are outside the water tank.
This makes all this big water wall isolation capacitor. For the purpose, hope you understood my expression.
Need high frequency, high voltage. I used 120V, 60Hz AC and it worked. After 15min you start to see rust coming off the metal in form of a could, like a smoke comes off the metal.
Another unusual effect that, rust removed only from ferromagnetic material, dielectric and paramagnetic don't react with capacitor field surrounded by water.
Now I will try to boost it with microwave transformer to see the effects, and not only the transformer, hope it works.. And also I want to try extract hydrogen and oxygen this way. If it works, if it works, will be no longer need of catalyzer plates. Can be used small peace's or granules. This way might be better than electrolysis.
Electric field rust removals are the same as electrolysis rust removals, only that electrodes are outside the water tank.
This makes all this big water wall isolation capacitor. For the purpose, hope you understood my expression.
Need high frequency, high voltage. I used 120V, 60Hz AC and it worked. After 15min you start to see rust coming off the metal in form of a could, like a smoke comes off the metal.
Another unusual effect that, rust removed only from ferromagnetic material, dielectric and paramagnetic don't react with capacitor field surrounded by water.
Now I will try to boost it with microwave transformer to see the effects, and not only the transformer, hope it works.. And also I want to try extract hydrogen and oxygen this way. If it works, if it works, will be no longer need of catalyzer plates. Can be used small peace's or granules. This way might be better than electrolysis.
5
Science Experiments / Hydrogen/Chloriтe fuel cell
« on: 11/02/2022 16:20:27 »
Is it possible?
Hydrogen fuel cells create electricity combining hydrogen and oxygen together. Same thing do hydrogen/chlorine gas. Than what materials will be needed to make this reaction happen.
Hydrogen fuel cells create electricity combining hydrogen and oxygen together. Same thing do hydrogen/chlorine gas. Than what materials will be needed to make this reaction happen.
6
General Science / When is the best point to add oxygen to a propane and hydrogen mix?
« on: 31/01/2022 20:48:25 »
Hello. 
If to blend propane with hydrogen. What would be better for burnout. To mix oxygen together or add it into the air next to burners?
If to blend propane with hydrogen. What would be better for burnout. To mix oxygen together or add it into the air next to burners?
7
General Science / Internal Combustion Engine question
« on: 29/01/2022 22:26:47 »
Hello.
If my cylinder walls are made of low carbon stainless steel. What material should the piston rings be made of?
If my cylinder walls are made of low carbon stainless steel. What material should the piston rings be made of?
8
General Science / isotope potassium-40
« on: 20/01/2022 01:03:24 »
About 70 years ago in Soviet Union lived a person. Who worked on a removal of radiation from metals.
He noticed that length of life of a human depend on how much radiation human body has. But the most interesting he said that our life shortened because of only one radioactive isotope on the planet, which is isotope potassium-40.
isotope potassium-40 is everywhere and in big amounts. The most isotope potassium-40 is in Bananas.
Now i hate bananas.
Does anyone knows any clues how to get rid of this from human body?
He noticed that length of life of a human depend on how much radiation human body has. But the most interesting he said that our life shortened because of only one radioactive isotope on the planet, which is isotope potassium-40.
isotope potassium-40 is everywhere and in big amounts. The most isotope potassium-40 is in Bananas.
Now i hate bananas.
Does anyone knows any clues how to get rid of this from human body?
9
General Science / co2 bomber extinguisher
« on: 15/01/2022 00:23:40 »
Hi. I come up with extinguisher that can kill forest fires. I call it CO2 bomb.
Looks like American-football ball, but bigger. inside is lots of liquid CO2.
Drop one in the forest fire. Valves will open and release huge amount of liquid CO2, which will become gas.
Looks like American-football ball, but bigger. inside is lots of liquid CO2.
Drop one in the forest fire. Valves will open and release huge amount of liquid CO2, which will become gas.
10
General Science / Pumping O2 and H2
« on: 04/01/2022 14:11:27 »
Hi.
Can i pump O2 and H2 with performance fuel pump for sport cars?
Can i pump O2 and H2 with performance fuel pump for sport cars?
11
General Science / Is this a feasible system for recycling CO2?
« on: 31/12/2021 23:24:37 »
HI. I designed a system to recycle CO2. Here is the small block diagram.
CO2RecStation.png (24.99 kB . 991x760 - viewed 2407 times)
And this one is for mobile version. You can place that on trucks, trains, diesel generators, rocket test rooms, wielding shops, farms etc.
CO2RecMobile.png (10.28 kB . 675x502 - viewed 2396 times)
Liquid CO2 unloads at the Truck or Train Station automatically or while refueling at gas station or shop. Diesel trains are the best.
CO2RecStation.png (24.99 kB . 991x760 - viewed 2407 times)And this one is for mobile version. You can place that on trucks, trains, diesel generators, rocket test rooms, wielding shops, farms etc.
CO2RecMobile.png (10.28 kB . 675x502 - viewed 2396 times)Liquid CO2 unloads at the Truck or Train Station automatically or while refueling at gas station or shop. Diesel trains are the best.
12
Science Experiments / Experiment with 3700W microwave transformer.
« on: 22/12/2021 14:16:16 »
Hi. Today no one makes such huge microwave transformers anymore.
It was in 2014. I was going back from school and found Panasonic microwave next to the garbage. Microwave was bigger than any I have seen and in the front panel was written 3700W. I opened it up and removed this transformer. Transformer was huge, about three times bigger than a regular microwave transformers and had two oversized pins on top. I took it home.
To be honest Im a fan of Nikola Tesla.
I checked that transformer with multimeter, not damaged. I plug into the wall outlet, measure the voltage across the secondary coil pins, don't remember exactly, 1500V. The pins of secondary coil was in a shape of transistor and had a hole in the middle. So, I took 50cm of a small transparent isolation wire and winded on through a hole in one pin which was to the right to me. Created some windings, the rest of the wire length was left 30cm after that. Than I took a small clear tape and wrapped around the same pin about 5 - 6 times. Took pliers and hold the tip of the small wire with them. With the other hand grabbed the electrical plug and shoved into wall outlet.
Right after that I noticed that the small wire escaping my pliers grip and dropping down. I don't know what would happen if the wire would be still in the pliers.
About after 30 seconds I hear electrical capacitor discharge sound like - click, after few seconds another one - click, and another. and sound keeps coming repeatedly. The small wire not in my pliers anymore. I look at the transformer where those clicks coming from and you wont believe this.
I hear another click and look at the transformer. I see a tiny bright dot appeared next to the left secondary coil pin. Not moving and growing in size, when the round electrical ball become size of a slim cigarette circumference, the ball moved quickly toward the second pin, passed through transparent tape isolation and without touching electrode, disappeared. I began to observe this. Few moments later I noticed that the sound - click comes every time big ball disappears and tiny dot appears, it is hard to say what is exactly was going on. After it grow quickly, the electric spinning ball, starts moving toward the other isolated pin, passes through the isolation tape and disappears without touching the other side. I moved back to the bedroom door and start looking. It was amazing view. But after few minutes transformer stopped making click noises.
I went downstairs checked the fuse box, everything was in position on. I took multimeter and measured the wall outlet, no power. Few more wall outlets had no power, so by the end of the day landlord call electrician. Electrician showed up next day. After work was done, he comes to me and asks what did I do. I told him absolutely nothing, than he showed me the back of the fuse removed from the house fuse box. It was in position on, but in the half of the back of a fuse gone, everything there was super melted. Electrician said that there is no such power around that can melt this fuse like that, the fuse was even fire proved. He asked me how I burned this fuse without melting the wires and insolation around them. I told him its a top secret. Than I got scared a bit. Because all this time I was sited in the room looking at the beautiful sparks appear and disappear. On the day after that I read in the local news paper that there was a problem with the local power station, something over there got burned.
Wow, what's the hell it was. Transformer and wires was ok, but the places with junctions and circuit brakers got burned all the way to PowerStation.
It was in 2014. I was going back from school and found Panasonic microwave next to the garbage. Microwave was bigger than any I have seen and in the front panel was written 3700W. I opened it up and removed this transformer. Transformer was huge, about three times bigger than a regular microwave transformers and had two oversized pins on top. I took it home.
To be honest Im a fan of Nikola Tesla.
I checked that transformer with multimeter, not damaged. I plug into the wall outlet, measure the voltage across the secondary coil pins, don't remember exactly, 1500V. The pins of secondary coil was in a shape of transistor and had a hole in the middle. So, I took 50cm of a small transparent isolation wire and winded on through a hole in one pin which was to the right to me. Created some windings, the rest of the wire length was left 30cm after that. Than I took a small clear tape and wrapped around the same pin about 5 - 6 times. Took pliers and hold the tip of the small wire with them. With the other hand grabbed the electrical plug and shoved into wall outlet.
Right after that I noticed that the small wire escaping my pliers grip and dropping down. I don't know what would happen if the wire would be still in the pliers.
About after 30 seconds I hear electrical capacitor discharge sound like - click, after few seconds another one - click, and another. and sound keeps coming repeatedly. The small wire not in my pliers anymore. I look at the transformer where those clicks coming from and you wont believe this.
I hear another click and look at the transformer. I see a tiny bright dot appeared next to the left secondary coil pin. Not moving and growing in size, when the round electrical ball become size of a slim cigarette circumference, the ball moved quickly toward the second pin, passed through transparent tape isolation and without touching electrode, disappeared. I began to observe this. Few moments later I noticed that the sound - click comes every time big ball disappears and tiny dot appears, it is hard to say what is exactly was going on. After it grow quickly, the electric spinning ball, starts moving toward the other isolated pin, passes through the isolation tape and disappears without touching the other side. I moved back to the bedroom door and start looking. It was amazing view. But after few minutes transformer stopped making click noises.
I went downstairs checked the fuse box, everything was in position on. I took multimeter and measured the wall outlet, no power. Few more wall outlets had no power, so by the end of the day landlord call electrician. Electrician showed up next day. After work was done, he comes to me and asks what did I do. I told him absolutely nothing, than he showed me the back of the fuse removed from the house fuse box. It was in position on, but in the half of the back of a fuse gone, everything there was super melted. Electrician said that there is no such power around that can melt this fuse like that, the fuse was even fire proved. He asked me how I burned this fuse without melting the wires and insolation around them. I told him its a top secret. Than I got scared a bit. Because all this time I was sited in the room looking at the beautiful sparks appear and disappear. On the day after that I read in the local news paper that there was a problem with the local power station, something over there got burned.
Wow, what's the hell it was. Transformer and wires was ok, but the places with junctions and circuit brakers got burned all the way to PowerStation.
13
Famous Scientists, Doctors and Inventors / How to sell your investion
« on: 22/12/2021 13:04:20 »
Hi. This is all sounds good and interesting to read. But, how do you find companies or people to invest or support your project?
Pages: [1]