Naked Science Forum
Non Life Sciences => Chemistry => Topic started by: eric2011 on 10/11/2023 17:49:29
-
What acid mixture can dissolve plastic when u sink the plastic in ? Then after a bit it can hardfen again
-
This cannot be done. If a plastic dissolves in an acid, the polymer will have been disrupted and the plastic will not be reconstituted. The same goes for basic dissolution.
-
The best way to soften plastics, and then later have them harden again is to melt them.
- Mild heat leaves the polymer chains intact, but temporarily mobilises them.
- Only works for thermoplastics...