Naked Science Forum
Non Life Sciences => Chemistry => Topic started by: eric2011 on 09/12/2023 20:40:03
-
Hi. I am thinking of meIting Plastic in a tight container such as a tin can or any other container with a tight lid . Putting PIastic stuff in and cIose it and then sit it in a hot fire. When the Plastic inside is meIting the inside Pressure can sc cause the container to burst or exIode?? I am doing this way because if I meIt the it with an container with no Iid the stuff evaorate in air. Whats you think guyz
-
Excuse the errors in the sentences. The device is broken
-
Heating anything in a completely sealed container is a bad idea unless you take suitable precautions.
Why do you want to heat plastic?
Many plastics can be melted in an open container.
-
Excuse the errors in the sentences. The device is broken
Errors in Sentences & Devices being Broken are one thing...
Your ' Thinking ' being Erroneous can literally Blow-up right in your face.
ps - half knowledge can lead to a half life.
* Please be Careful & Tc!
-
Heating anything in a completely sealed container is a bad idea unless you take suitable precautions.
Why do you want to heat plastic?
Many plastics can be melted in an open container.
I want to meIt ABS and HD PE but when I do it in an uncovered container the PIastics EVAPORATES. I want to ment and POUR in mouIds to create other things.
-
Excuse the errors in the sentences. The device is broken
Errors in Sentences & Devices being Broken are one thing...
Your ' Thinking ' being Erroneous can literally Blow-up right in your face.
ps - half knowledge can lead to a half life.
* Please be Careful & Tc!
What is the best way to meIt plastics without the plastics evaorate i on air?,
-
Do you realise that molten plastics are usually very viscous liquids?
If they are evaporating you are getting them too hot.
Plastics are usually poor conductors of heat. The outside will get too hot before the inside melts unless you heat them in a temperature controlled way.
-
@eric2011
I am Tempted to tell you a few ways...
But they are All based on Wiki/Net data.
And Any&All information on the Internet canNot be Trusted atall.
Personally, I've seen Plastic burn.
If all of it is Evaporating, then it's turning into Vape.
I donno what Exactly happens if one inhales Plastic Fume, knowingly or unknowingly, but I'm Dead Sure the End result on the eyes, nose, mouth, lungs etc etc is Not Good Atall!
ps - rather than Plastic, wish you were interested in Pottery instead.
might have been Easier to sell whatever by branding it Eco-Friendly.
Anyways, TC!