[Petrochemicals (OP)]

Not counting efficiency, could the diesil engine be made clean ? Deisel engines where initially used for there high torque output espexially at the low end of engine rpm compared to petrol engines, lorries buses tractors etc used them as they provide lots of slow constant power. It is only in recent years diesils heve become popular because the fuel takes less energy to create ie refine and is more efficient and given that turbo diesils have developed, they also now give higher acceleration, somewhere near that of petrol engines. We have all been told by different mechanisms to buy deisels and then not to, yet it doesnt seem that we will be getting rid of large diesil vehicles any time soon, as even though a bus could run off petrol, it is likely that the efficiency versus the present diesil engine would be far far below the efficiency of having a bus with a diesil engine and that means citys and motorway avenues full of dioxins from diesil.

Unfortunatley as anyone with a brian and a bit of experience could have told the governments of earth before they started pushing diesils,  what comes out of a diesil exaust is very very toxic. Is there any reasonable way to process the exaust gasses such as reburning the exaust ( efficiency not withstanding) whilst the vehicle remains largely as mobile and as maintainance free as prior to modification.

[Bored chemist]

Is there any reasonable way to process the exaust gasses

Yes.
https://en.wikipedia.org/wiki/Diesel_particulate_filter

On an unrelated note, do you know that some web browsers contain a spelling checker?

[alancalverd]

Diesel exhaust can in principle be much cleaner than petrol exhaust as the initial combustion phase is more complete and the exhaust temperature is fairly constant so you can clean it up with catalysts. The problem is that the peak efficiency is limited to a fairly narrow speed range, which is why trucks have as many as 24 gears - the engine speed may be limited to 950 rpm idle and 1200 rpm maximum.

This isn't a problem on ships, where you can run a huge stratified-charge engine for several weeks at 120 rpm, and may be an advantage in future aircraft running a small turbine at 10,000 rpm and delivering thrust via contrarotating electric propellors. My hope is that someone (I'm too old to start the project now) will produce a diesel-electric drive train for cars with a 100 HP diesel running at 2500 rpm charging a battery for overtaking (150 - 200 HP delivered to short-term overdriven electric motors) and town driving (diesel off, 25 HP from the battery) with 80 HP cruise power available, so the diesel is either at optimum power setting or off.

The best thing to to with government advice, whether on wind power, salt, fat, or diesel emission,  is to ignore it.

[Petrochemicals (OP)]

Is there any reasonable way to process the exaust gasses

Yes.
https://en.wikipedia.org/wiki/Diesel_particulate_filter

On an unrelated note, do you know that some web browsers contain a spelling checker?

Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Diesel Deisel

The filter does not remove all particles, leaving the smallest most dangerous there, being the smallest there will be more particles per quantity too. And filters soon become blocked. With it being a fuel oil too, there are more pollutants in the mix than petrol.

[alancalverd]

At least one manufacturer (Saab) has demonstrated that the exhaust from an optimised diesel engine was cleaner than the city air it was breathing in.

All flters can get blocked but a modern DPF has an automatic  cleaning cycle that oxidises the deposits or flags up its condition if it can't be cleaned. This resolves the particulates problem for cars and trucks, which occasionally travel long distances at high speeds (when the DPF can get hot enough to clean itself) but probably not for city buses and taxis. Sadly, our lords and masters seem keen to prevent cars and trucks from entering their domains, and to promote the public transport that causes the problem.

[chris]

Diesel exhaust can in principle be much cleaner than petrol exhaust as the initial combustion phase is more complete and the exhaust temperature is fairly constant so you can clean it up with catalysts. The problem is that the peak efficiency is limited to a fairly narrow speed range, which is why trucks have as many as 24 gears - the engine speed may be limited to 950 rpm idle and 1200 rpm maximum.

This isn't a problem on ships, where you can run a huge stratified-charge engine for several weeks at 120 rpm, and may be an advantage in future aircraft running a small turbine at 10,000 rpm and delivering thrust via contrarotating electric propellors. My hope is that someone (I'm too old to start the project now) will produce a diesel-electric drive train for cars with a 100 HP diesel running at 2500 rpm charging a battery for overtaking (150 - 200 HP delivered to short-term overdriven electric motors) and town driving (diesel off, 25 HP from the battery) with 80 HP cruise power available, so the diesel is either at optimum power setting or off.

The best thing to to with government advice, whether on wind power, salt, fat, or diesel emission,  is to ignore it.

Very interesting post @alancalverd

You refer to drive trains for cars based on a diesel electric hybrid principle. You might recall we covered a similar technology for London's ageing bus fleet:
https://www.thenakedscientists.com/articles/interviews/hybrid-buses-are-coming-london

[Petrochemicals (OP)]

AlanCalvert heve you a link on this please, as i cannot seem to find one.

The city bus link only states the better mpg because of no idling, so does this mean significant losses in the conversion to electric.

[alancalverd]

Nothing more detailed from me, I'm afraid, but I think the transcript was a bit inexplicit. The trick he explained was that the diesel engine is either running at peak efficiency or switched off, but without actual figures it's difficult to see if the system could be extended as I suggested to deliver short-term overpowering of the electric motor. This probably isn't necessary for a city bus, which has a limited speed range and doesn't need to overtake anything faster than a bicycle.

[Galaser]

Looking forward to one.

[Petrochemicals (OP)]

https://patents.justia.com/patent/3952507

Could something like this be used to burn all the unburned fuel, or would the particulates be too small or inconbustable.

[alancalverd]

A bit more complicated than just using a catalyst and recovering the heat energy with thermocouples, and returning zsecondary combustion products to the carburetor will surely reduce the efficiency of the primary engine?   

[Petrochemicals (OP)]

A bit more complicated than just using a catalyst and recovering the heat energy with thermocouples, and returning zsecondary combustion products to the carburetor will surely reduce the efficiency of the primary engine?   

Well the lowering of efficiency is acceptable to a point. The diesil engine is superbly efficient as compared to the petrol engine in high torque situations, seriously something like twice or more than petrol,  so even if they lowered the efficiency by 25 percent to have clean air you would be quids in.

I do not think it is a recirculation system, where only a portion of exaust is returned, its more like a secondary engine chamber, more air and therefore oxygen is taken in to the exaust system and an attempt at ignition takes place, i should think that most of the particulates are partially combusted material, so new oxygen would be needed. I was thinking that the mixture may be too dilute for ignition by that stage, or the particulates incombustable. If the problem is the fact that the diesel in the cylinders is expected to perform a function ?Even if you added a bit of super heated extra diesil to getting the ignition going this would be easily efficient enough for the bus and lorry application.

[teragram]

A bit more complicated than just using a catalyst and recovering the heat energy with thermocouples, and returning zsecondary combustion products to the carburetor will surely reduce the efficiency of the primary engine?   

Carburetor??

[alancalverd]

If you have combustible particles in the exhaust you should have run the engine slower, with more oxygen!

[teragram]

My hope is that someone (I'm too old to start the project now) will produce a diesel-electric drive train for cars with a 100 HP diesel running at 2500 rpm charging a battery for overtaking (150 - 200 HP delivered to short-term overdriven electric motors) and town driving (diesel off, 25 HP from the battery) with 80 HP cruise power available, so the diesel is either at optimum power setting or off.

Why a "short term overdriven electric motor"? The average electric vehicle has an electric motor which very capably copes with all running conditions, cruising, acceleration, town traffic...The best situation is an electric car with an engine used only for charging the battery. The engine can then be run at a constant speed corresponding to it's maximum efficiency, something in fact like the BMW i3 with "range extender", although this is a petrol engine. Electric motors are far better at moving vehicles than piston engines.
Incidentally (my apologies for being picky) diesel engines do not have a carburettor.
On second thoughts, the "best solution" is not to have a heat engine at all.

[Bored chemist]

Obviously, all this depends on the definition of "clean".
Teh production of CO2 is still a problem.

[Petrochemicals (OP)]

Obviously, all this depends on the definition of "clean".
Teh production of CO2 is still a problem.

Weve been through this before, co2 is not the problem its water vapour heating the earth !

[alancalverd]

CO2 is not a problem. It is the basis of plant growth, on which all animal life depends. The climatic fragility of human civilisation is a problem, which is in our power to solve. But we won't.

[alancalverd]

Why a "short term overdriven electric motor"?

The maximum power obtainable from modern electric motors is limited by their temperature rise. You can water-cool a motor to optimise its continuous-power to weight ratio, and allow short-term overdrive of around 20% of max continuous for takeoff. This is common with aircraft engines which have cruise (optimum fuel consumption), METO ("maximum except takeoff") used for continuous climb, and MAX2MIN settings for getting off a short runway. Might just be useful for road transport, particularly for heavy goods vehicles.

The "range extender" logic baffles me. If your car needs say 50 horsepower to maintain 60 mph, then you need a 50 HP electric motor AND a 50 HP petrol engine for when the battery runs out. Either that, or you have to run say a 10 HP engine continuously to trickle charge the battery, and in either case carry enough liqjuid fuel to run the car for x miles at 60 mph where x is the range extension. 

[KevinSalyer]

Firstly, sediment diesel oil. Usually after sediment 96 hours, 0.005 mm of particles can be removed. The longer the sediment  time is, the more obvious the removal effect of minor impurities which can not be removed by the filter is.

Then, when use diesel oil which has sediment, do not shake it. A sucker or hose for pumping can not be inserted directly into the bottom of the barrel, leave at least 80-00mm away from the bottom of the barrel, refueling cannot be done by pouring oil in an inclined drum. As for diesel oil below 80-100mm in oil drums, they can be centralized and reused after precipitation and filtration.

When refueling, it must be filtered, this is to prevent mechanical impurities from entering the final pass of diesel engine, when refueling with sucker or self-flow method, it is better to filter with fine cloth or other filter material.

So how to store diesel oil is also important.